@Tshulthise wrote:
This is one of those times where I hate MeshCAM. Such a simple task and I can't make it do it no matter what I try...
I start with the attached STL. I'll attach some renderings for reference.
I've already machined the outer edges which worked fine. Now I want to machine the slot in the center (only)... but MeshCAM simply will not do it. I want to use a 1/8" endmill. The slot is 0.130 wide. You can see that I've defined the zone to machine. It no workie. As you can see, MeshCAM just tries to peck at it 1000x which won't work.
ENTRY DUCT.stl (100.5 KB)
Posts: 5
Participants: 2